I have to configure this switch.
Cisco 2960x stack cable connection.
I found documentation for connecting 3 or more switches for maximum redundency but nothing for only 2 switches.
When you connect the flexstack cable to the stack 1 port the tab should be above the connector.
If the cable is bad replace it with a known good cable.
Configure the pc terminal emulation software for 9600 baud 8 data bits no parity 1 stop bit and no flow control.
Step 2 insert one end of the flexstack cable into the stack port of the first switch.
Start a terminal emulation program on the pc.
You can connect only one switch type in a stack or you can connect a mix of catalyst 2960 x and catalyst 2960 s switches in the stack.
Figure 1 17 connect the flexstack cables.
The stack can have one of these configurations.
Remove and inspect the stack cable and stack port for bent pins or damaged connectors.
It connects up to eight cisco 2960 x series switches in a stack that functions as a single local switch.
Always use a cisco approved flexstack cable to connect the switches.
Connect an usb cable to the pc usb port.
C2960x stack datasheet get a quote overview c2960x stack is a cisco catalyst 2960 x and 2960 xr series switches flexstack plus stacking module which allows these switches stack with each other to offer flexible management.
You must remove any cable or device that causes a poe fault.
This is only supported on the stack capable switches.
Highlights flexstack plus is the name of the stacking technology used by the cisco catalyst 2960 x and 2960 xr series.
Hello i am connecting 2 ws c2960s 48fps l.
Connect the other end of the cable to the mini b 5 pin connector usb port on the switch.
Yes you make a single logical switch when you connect switches using stack cable.
A connect master stack port 1 member stack port 1 master stack port 2 member stack port 2 or b conn.
Insert the other end of the cable into the stack port on the other switch.
A switch stack is a set of up to eight stacking capable switches connected through their stack ports.
The c2960x stack is a catalyst 2960 x series flexstack plus stacking module.
Applies to the catalyst 2960x 24psq l switches.
Use only standard compliant cabling to connect cisco prestandard ip phones and wireless access points or ieee 802 3af compliant devices.
Cisco 2960x stack configuration.
Make sure you insert the cables in completely until you feel them snap into place.
