Despite drying out the rubber seal and leaving the door open after every use i still have mold.
Cleaning mold from washing machine door seal.
I have just been tackling it this week.
Use a cleaner and a toothbrush to remove mold from rubber seal effectively.
Grab a towel or rag and dip it in hot soapy water and scrub away.
I have used small tweezers to remove muck from behind the gasket when i m done with all my washing i wash about 4 loads once a week.
This door seal collects build up from the suds from the soapy water and allows mold growth.
Though you just spent a mint on your new front load washing machine you can experience mold problems even with a new machine.
As a result there usually isn t enough moisture on the gasket to allow mold to grow.
Water is often trapped in the rubber gasket around the door and over time this leads to the growth of mold.
Front load washers are especially prone to developing mold around the rubber door seal.
You should also clean the outside of the washer door after you remove mold from rubber seal on washing machine.
I have also used paper towel to clean the gasket door seal and glass but the mold continued to be a problem.
Sometimes our clothes would come out of the washing machine with bits of grime on them and our machine was smelling moldy.
Then check out these three areas to be sure you properly remove mold.
As with the process of cleaning your machine the easiest way to clean the rubber seal is to run a number of wash cycles first.
How to clean mold off the rubber seal on a front load washer.
Clorox bleach gel works best https amzn to 30l26zh how to remove mold from the washing machine rubber gasket using baking soda clorox bleach vinegar h.
The only way to deal with the problem of mold on the rubber seal of front load washer is to clean it regularly using the steps below.
It might seem counterintuitive but the best way to prevent mold on a washing machine seal is to leave the door open.
I have been using weiman washing machine cleaner deodorizer for about a year.
You can also use non toxic bathroom cleaner to get rid of mold and mildew or take advantage of hydrogen peroxide as an excellent choice for mold removal too.
How to clean a washing machine rubber seal.
I have the same black mold problem with my fisher and pykel front loader.
The gasket is the rubber seal that keeps water from squeezing around the washer door.
